- Fuel Cell Plates
- Fill & Vent Plates
- 6X10 Plate With Fill & Vents
Designed to work with aftermarket fuel pump assemblies, this fill plate can be fitted with any in-tank fuel pump assembly utilizing a 4.00" diameter bolt center mounting pattern, including the Aeromotive Stealth fuel pump line or Weldon 1100A Flanged in-tank pump.
- 6X10 Aluminum Plate 6061-T6 (24 Bolt Oval)
- .25" Perimeter Flange
- 2.50" Quick Fill Neck
- 3.50" Anti-Spill Valve
- 1.00" Quick Fill Vent
- SAE 5 Hole Sending Unit Cutout
- 4.00" B.C. 10 Bolt Cutout
- 6X10 Cork & Buna Gasket
- Raw Aluminum or Clear Anodized Finish
Designed to utilize modern aftermarket fuel pump assemblies, this fill plate features a 10 bolt cutout specifically designed to utilize aftermarket fuel pump assemblies from Aeromotive Inc. and Weldon Racing Pumps (among others). The cutout features a 10 bolt circular pattern with a bolt center diameter of 4.00" (101.6mm) and is drilled and tapped to accept 10-32 bolts (included). The 3.50" (89mm) internal cutout allows large diameter fuel pumps and fuel assemblies to be installed without modification to the fill plate. The 2.50" fill neck and 1.00" check valve allow quick fueling and the SAE 5 hole cutout is configured to accept most aftermarket fuel level sending units. Additionally, the configuration allows for drilling and installation of additional fittings, if necessary. Finally, the .25" perimeter flange evenly distributes the weight of the unit around the outer shell to both cover and protect against debris.